BMW (BMWG.DE) plans to announce in July that it will build its first assembly plant in Mexico and has earmarked two regions where the site could be built, Automobilwoche reported on Sunday, without citing the source of the information. With numerous

The market for plastic molds for phone components will rise rapidly in 2014. With millions iPhone 5c smartphones sold, it represents a total consumption of tons of PC resin by just one device. With the introduction of the 5c, Apple is part of a risin

Theres no getting around the fact that General Motors is taking a clubbing right now. A huge recall, several lawsuits, a blistering congressional hearing, apologies to consumers, potential criminal investigations -- its all bad. But then there are th

nder the hot molten alloy, semi-solid alloy scouring, and maintain a pressurized working under the state of aluminum alloy casting dies after a period of use, the protection layer on the surface of the general will form a mesh micro crack, crack and

Built by a team of 26 students at the Eindhoven University of Technology, the Novafeatured, among other things, bio-fiber reinforced body panels produced using Nouryact cobalt-free accelerators from AkzoNobel.AkzoNobels innovative curing system enabl

A nearly two-decade partnership with a German software supplier has helped a Scandinavian tool and injection moulding company thrive in new markets. Nestled next to the quiet Norwegian coastal town of Levanger, mould maker Induform AS has been produc

Plastics recycling will continue to grow; it was confirmed during this year EUPR Annual Meeting, which took place on 21st and 22nd of November in Brussels. The event was devoted to the subject of: Resource Efficiency for Plastics. It has turned out t

Plastic Mould Problems Solution Plastic Mould Defects-Dull spots near the sprue Dull spots near the sprue are mainly caused by: small gates high injection speeds Due to high injection speeds, small gate cross-sections and by-passes behind the gate, e

Gasgoo.com (Shanghai Feb 19th) A total of 379,900 units of imported vehicles received inspection from the Inspection and Quarantine Bureau of Tianjin, a city in north China, with a year-on-year decrease of 31.4% in 2015. Explosions in Tianjin Port ha

Gasgoo.com (Shanghai April 25 th ) According to an announcement of Dongfeng Motors released in the evening of April 22nd, the company plans to sell its share of Zhengzhou Nissan Automobile to its controlling shareholder Dongfeng Motor Co., Ltd. so as

PPS is a good material for replacing metal and thermosetting plastics thanks to its strong array of performance properties. Sulfur in a plastics molecule indicates heat resistance. Polyphenylene sulfide (PPS) shares that distinction with polysulfone

The injection molding of micro parts calls for innovative hot runner solutions to comply with the demands of injection molders and toolmakers. The injection molding of precision and micro parts creates special demands on the moldmaker and hot runner